A great little ripper for outdoors. An Open Prop Micro takes a whoop size frame and is set up to be more powerful so it can be flown outside.
This 1.6 inch frame can swing 1.77inch (45mm) props so we take advantage of this and pair these with 1002 size motors to make an agressive flying micro freestyle.
The ERVT has everything you need on one board.
FC / ESC
Analog VTX
ELRS Rx (on UART)
If you are not using the supplied XT30 connector, then use BT2.0 connectors. VTX and ELRS antennas are included.
Camera Choice 1:
10mm lens diameter make this superlight camera a perfect fit.
Camera Choice 2:
With a 10mm lens, this camera also comes in a 16:9 ratio (link)
25.5 x 25.5mm Mount
FC / ESC as well as HDZero VTX and ELRS Rx onboard. Note: ELRS is SPI not UART. Camera wires need to be soldered but motors are plug in (Molex).
Camera Choice1:
14mm Mount
Camera Choice1:
14mm Mount
ELRS is serial based. Note that with Walksnail you will need to mount the VTX above the FC making it a bit heavier build. You will also need to solder the motor wires – not actually a bad thing. Sypplied with XT30 connector. Swap for BT2.0 connectors. to match your battery.
25.5 x 25.5mm Mount
1S – 3S / 14mm Cam
Motor Choice 1:
Molex Connectors make these plug n play with the HD Zero AIO5.
Motor Choice 2:
Molex Connectors make these plug n play with the HD Zero AIO5.
Motor Choice 3:
No plugs on these motors so a good choice for the Analog or Walksnail electronics packages above.
This frame has clearance for 1.77 inch props even though it’s a 1.6 inch frame. A Choose any 1.77 inch 3 bladed prop.
Choose a 1S battery about 500 – 550 mAh. The battery bay holder is 16mm x 7mm but can stretch, so check your battery size.
All electronics packages above include onboard ELRS receivers.
